Skill level: Simple - similar to installing a stall motor switch machine. For DCC you should understand how to operate accessories with your DCC system.
New! Singlet Micro DCC Accessory Decoder
Designed exclusively for switching turnouts with a servo
No buzzing! - servo turns off at end of throw
Simpler setup - center the servo and mount - no alignment needed
Switch with DCC or the included fascia controller
Teach the DCC address with a jumper - no CVs to program
The singlet has a baby brother, the Micro Singlet. It is a simple servo decoder designed to drive turnouts and only turnouts. It solves the problem of servo buzzing by turning the servo off at the end of the throw. Special circuitry and programming has been built in to accomplish this without a large jerk at restart.
The Micro Singlet works has a fascia controller for controlling the turnout manually. It is the same fascia controller used by my other servo boards. The Micro uses a pushbutton to throw the turnout. If you are in love with toggles you will need the older Singlet (see below) or the SwitchWright.
Installation is simple. It is designed to work with a servo under the table using the geometry of the SwitchWright bracket. This mounting method provides an over the center spring action that keeps the points in place after the servo turns off. After years of trying various methods this method really works the best and avoids the servo buzzing that happens when they are fighting to keep the points in place. Centering for mounting the servo is done by holding down the fascia controller button until the servo drives to the center. A tap on the button releases it.
The video (left) shows the Micro Singlet and a servo mounted on a SwitchWright bracket. It also works very nicely with the Micro Switch machine as pictured above.
Micro Singlet Servo Decoder with Fascia Controller
Includes the micro singlet, with a Red/Green Bi-color Fascia Controller. Power is provided from the DCC bus or from 8-24V DC if you just want to use the fascia controller.
Each unit requires about 0.15 A when moving points and about .025 A when resting.
OUT OF STOCK MSS002 $15.49 USD
Micro Singlet Servo Decoder Board Only
Just the Micro Singlet board. Requires a servo. For manual operation a pushbutton or a fascia controller is needed. Each unit requires about 0.15 A when moving points and about .025 A when resting.